Vision VISION-64 Guía de usuario descargar pdf (Pagina 84)

84 Vision Software User's Guide

When determining the parameters for arcing, it is helpful to think of a circle

with the text going around the circle. We need to place the circle on our

plate in a certain area.

X Center: This number will determine where the arc is from left to right on

our plate. It is calculated from the left side of our plate.

Y Center: This number will determine where the arc is from top to bottom

on our plate. It is calculated from the top of our plate.

Note: The X & Y centers are the points of rotation of the arc. If

the wrong numbers are entered, the text can actually be off of the plate.

Arc radius: This number will determine the radius of the arc. The radius is

measured from the center point of the arc (X & Y Center) to the inside of

the text. The larger the number is, the larger the arc will be.

Start angle: This number will determine the degree amount that the arc will

start.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 186 187

Sin comentarios

Vision VISION-64 Guía de usuario Pagina 84