Vision Multi Axis Especificaciones descargar pdf (Pagina 15)

Chapter 3 - Operations 15

3) If the distance is greater than 1 1/2”, loosen the height adjustment screw shown below in figure 3.6. Then raise or lower the vice

until the spacing is approximately 1 1/2“ and tighten the height adjustment screw.

(Figure 3.6) The height adjustment knob

Open the vice up so that the spindle nose cone will fit inside. Then press the Z jog down button until the spindle is

down inside the clamp. (see figure 3.7)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 40 41

Sin comentarios

Vision Multi Axis Especificaciones Pagina 15