Vision Multi Axis Especificaciones descargar pdf (Pagina 37)

Chapter 5 - Maintenance 37

DO NOT use any lubricant other than silicone, as it may become sticky and cause a buildup that can cause mechanical

failure.

(Figure 5.2) The Lubrication Areas

(Figure 5.3) The Lubrication Areas

What not to lubricate

Many of the bearings and assemblies in your engraving machine are sealed and/or coated using special low-friction

methods and should not be lubricated.

DO NOT attempt to lubricate the spindle or the spindle bearings. If you suspect lubrication problems, call your

dealer/representative for instructions, as further lubrication may harm the machine.

DO NOT oil the X or Y stepper motors. None of the motors on the MAX Engraver require lubrication. Oiling the

stepper motors can permanently damage the motors.

1 2 ... 32 33 34 35 36 37 38 39 40 41

Sin comentarios

Vision Multi Axis Especificaciones Pagina 37