Vision Multi Axis Especificaciones descargar pdf (Pagina 19)

Chapter 3 - Operations 19

Press the Y jog buttons on the Vision Series 3 Controller to move the spindle towards the center of the object you are

engraving.

The distance between the bottom of the spindle and the object you are engraving should be approximately 1 1/2”. If

it is not 1 1/2“, loosen the height adjustment knob and raise or lower the clamping device. See figure 3.13 for height

distance.

(Figure 3.13) Setting the height adjustment

Adjust the verticle position of the clamping device. To do this, loosen the vertical movement adjustment knob as

shown below in figure 3.14.

(Figure 3.14) The vertical movement adjustment knob

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 40 41

Sin comentarios

Vision Multi Axis Especificaciones Pagina 19